Epson TM-U950P Operation Manual - Page 36
Adjusting the Paper Near End Detectors, ESC c 4 - software
View all Epson TM-U950P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Adjusting the Paper Near End Detectors The paper near end detectors detect when the paper is almost gone by measuring the diameter of the paper roll. Software programs can use the ESC c 4 command to stop printing when the paper is almost gone. If you want to change the amount of paper remaining when the printer stops printing, follow the steps below to adjust either paper near end detector. Note: The printer also has two paper end-sensors that stop the printer at the very end of a roll. These sensors cannot be turned off by software. 1. Open the printer cover and remove the paper roll. 2. Determine the point on the paper roll at which you want the paper roll end detection to be triggered. Then measure the distance A shown in the illustration. distance A Note: There may be some difference between the measured distance A and the actual sensing position. 1-26 Setting Up the Printer