Fluke 287/FVF Product Manual - Page 59
Viewing Memory Data, Viewing Snapshot and Summary Data, Viewing Trend Data
View all Fluke 287/FVF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
287/289 Users Manual saved under the name of Save-2. The auto-incrementing number can be reset to 1 by positioning the menu selector next to the save name and then pressing the softkey labeled Reset #. To save a screen shot, a recording session, or MIN MAX or Peak record session, press the softkey labeled Save. To select the name from the preset list, press +Name. To save to the same name as before but with the next number, press the softkey labeled Save. This second method makes it easy to save a series of measurements simply by pressing the Save softkey twice for each save operation. When selecting the name for a save operation, position the menu selector next to the desired name using the cursor buttons. Next press the softkey labeled Save. Viewing Memory Data Viewing data stored in the Meter's memory is performed through the save menu. Press the softkey labeled Save. Position the menu selector next to the menu item labeled View Memory and press the softkey labeled View. Note To view data stored in memory, the Meter must not be recording or performing a MIN MAX or peak record session. The Meter separates stored data into four different categories: Measurement, MIN MAX, Peak, and Recording. Use the cursor buttons to position the menu selector next to the desired saved data category and then press the softkey labeled View. The Meter displays the last record saved for the selected data category. 50 If there are previously stored records, press the softkey labeled Prev or 5 to page back through previously stored records. Press the softkey labeled Next or 6 to page in the other direction. Press Close to return to normal Meter operation. Viewing Snapshot and Summary Data After selecting the MIN MAX, Peak, or Measurement category described in the Viewing Memory Data section above, pressing View only displays the information stored at the time a Save was performed. The display is reconstructed from this data when viewed. Viewing Trend Data For the Recording category, the interval and event data stored during a recording session are viewed on the Meter through a trend-plot view, similar to a strip-chart recorder. See the "Recording Measurement Data" section later in this manual for an explanation of interval and event data. After selecting the recording category described in the Viewing Memory Data section above and pressing View, the recording session's summary screen is displayed (See Table 9). Press the softkey labeled Trend to display the recorded data in a trend-plot view. Table 7 shows the trend view along with a description of each of its components. To look at data stored in the individual records that make up the trend, move the cursor to any point along the plot by pressing 6 or 5. The value and timestamp of the minimum, maximum, and end-of-record values of the selected record are displayed at the bottom of the cursor. All data contained in a record can only be viewed on a PC running FlukeView Forms. MyFlukeStore Shop for Fluke products online at: www. .com 1.888.610.7664