Frigidaire FFHB2740PE Use and Care Manual - Page 12
CAUTION, Removing Freezer Drawer, Installing Freezer Drawer
View all Frigidaire FFHB2740PE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
DOOR REMOVAL INSTRUCTIONS Removing Freezer Drawer 1 Open freezer drawer. 2 Remove drawer screws on right and left sides (two screws on each side). Remove Hex Head Drawer Screw Do Not Remove Other Screws Remove Hex Head Drawer Screw Do Not Remove Other Screws Remove Hex Head Drawer Screw Remove Hex Head Drawer Screw NOTE Do not remove center screw from freezer drawer. This is a factory adjustment. CAUTION Drawer is heavy. Use caution when lifting. 3 Lift drawer up and out to remove. Installing Freezer Drawer 1 With lower slides pulled out, hang drawer onto slide brackets ensuring pins on each side are fully inserted into slots on each side. Drawer Assembly Fully Extend Drawer Slides Pin Slot Cabinet 3 Check gasket seal around top, bottom, and sides of freezer drawer. 4 If gasket is not sealed, open drawer and slightly loosen four drawer screws (two on each side) to allow drawer to rotate. 5 Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer. Push Against Freezer Drawer Grab Drawer At Center From Both Sides Then Pull Drawer Out 2 Reinstall four drawer screws (two per side), tighten down, and close drawer (C). A B Install Screws (2) Each Side 6 Tighten four drawer screws. 7 Recheck gasket seal. 8 Install the toe grille by fitting into place. 12