Frigidaire FFHB2740PE Use and Care Manual - Page 19

CONTROLS Options May Vary options (∧ or ∨) Used to enter and exit the options menu and make selections. exit Toggles the options and run modes. control locked While in the locked state, you will not be able to change any settings on the display nor dispense ice and water. The "Control Locked" indicator will flash and an audible warning tone is played. quick freeze on off Activates a faster rate for freezing food and increases ice production in the freezer. Deactivates after 12 hours. ice maker on off Toggles the ice maker "ON" or "OFF". In the "Ice Off" state, indicator will blink when ice is dispensed. display on off Toggles the temperature displays On and Off. refrigerator temp Allows the temperature setpoints to be adjusted. Control temperatures range from +33° F / +1° C to +47° F / +8° C. freezer temp Allows the temperature set-points to be adjusted. Control temperatures range from -6° F / -21° C to +6° F / -15° C. mode ° F ° C Toggles display from Fahrenheit to Celsius. light Toggles dispenser light On and Off. power off Press and hold for three seconds to turn off the cooling system. It also turns off the ice maker and all dispenser functions. The display will read "power off". water filter Displays the current status of the water filter (Good, Order, or Replace). To reset the filter status to "Good", press and hold the "set" key for three seconds. air filter Displays the current status of the air filter (Good, Order, or Replace). To reset the filter status to "Good", press and hold the "set" key for three seconds. default settings While in the default option, press and hold the set key for three seconds to reset all refrigerator settings to their factory default settings. set (+ or -) Selects the current menu selection option. water Press the "water" key to select water. A green indicator light will be illuminated above the active feature. cube Press the "cube" key to select cubed ice. A green indicator light will be illuminated above the active feature. crush Press the "crush" key to select crushed ice. A green indicator light will be illuminated above the active feature. Setting cooling temperatures (options may vary)  NOTE When you first power on the refrigerator, the temperature displays 0° F and 37° F. After a few seconds, both of the displays will switch to "HI". The displays will continue to show "HI" for 20 minutes. After 20 minutes, the High Temp alarm will sound and both displays will show the actual temperature. 1 Plus (+) and Minus (-) indicators are located on the right side of the control panel. 2 Press the + or - indicator to adjust the temperature to the desired setting. 19