Frigidaire FFHB2740PE Use and Care Manual - Page 7

INSTALLATION Leveling Freezer Drawer (if necessary) To level the freezer drawer: 1 Check gasket seal around top, bottom, and sides of freezer drawer. 2 If gasket is not sealed, open drawer and slightly loosen four drawer screws (two on each side) to allow drawer to rotate. Remove Hex Head Drawer Screw Do Not Remove Other Screws Do Not Remove Other Screws Remove Hex Head Drawer Screw Remove Hex Head Drawer Screw Remove Hex Head Drawer Screw 3 Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer. Push Against Freezer Drawer Grab Drawer At Center From Both Sides Then Pull Drawer Out • Doors should align with each other and be level. Most of these conditions can be met by raising or lowering the adjustable front rollers. To level the cabinet using the front rollers: Toe Grille Must Fit in Slot on Anti-tip Bracket Screw/Washer Assembly A B (3) Retaining Clips 4 Tighten four drawer screws. 5 Recheck gasket seal. Level Refrigerator & Adjust Doors (if necessary) Guidelines for final positioning of your refrigerator: 1 Slightly open freezer drawer. Lift the toe grille and gently pull forward (see illustration). 2 You can raise or lower each door. Use a ⅜ inch socket wrench to turn the adjustment screws (one per side). To raise: turn adjustment screw clockwise. • All four corners of the cabinet must rest firmly on the floor. To lower: turn adjustment screw counterclockwise. • The sides should tilt ¼ inch (6 mm) from front to back (to ensure that doors close and seal properly). 3 Ensure both doors are bind-free with their seals touching the cabinet on all four sides and that cabinet is stable. 7