Fujitsu MBA3073NC Product Manual - Page 75
Installation
View all Fujitsu MBA3073NC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
CHAPTER 5 INSTALLATION 5.1 Notes on Handling HDDs 5.2 Connections 5.3 Setting Terminals 5.4 Mounting HDDs 5.5 Connecting Cables 5.6 Checking Operation after Installation and Preparing the HDDs for Use 5.7 Dismounting HDDs This chapter describes the notes on handling HDDs, connections, setting switches and plugs, mounting HDDs, connecting cables, confirming drive operations after installation and preparation for use, and dismounting HDDs. 5.1 Notes on Handling HDDs The items listed in the specifications in Table 2.1 must be strictly observed. (1) General notes a) Do not give the HDD shocks or vibrations exceeding the value defined in the specifications because it may cause critical damage to the HDD. Especially be careful when unpacking. b) Do not leave the HDD in a dirty or contaminated environment. c) Since static discharge may destroy the CMOS semiconductors in the HDD, note the following after unpacking: • Use an antistatic mat and body grounding when handling the HDD. • Hold the DE when handling the HDD. Do not touch any components on the PCBAs except setting terminal (CN1 and CN2). CAUTION High temperature To prevent injury, never touch the HDD while it is hot. The DE and LSI become hot during operation and remain hot immediately after turning off the power. C141-E270 71 Downloaded from www.Manualslib.com manuals search engine