Fujitsu MBA3073NC Product Manual - Page 95
Refer to Data Buffer Management of the SCSI Logical Interface Specifications
View all Fujitsu MBA3073NC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Notes: 1. The user can arbitrarily specify the following parameters according to the system requirements: • ARRE • AWRE • TB • PER 2. The user also can arbitrarily specify parameters other than the above. However, it is recommended to use the default setting in normal operations. (2) Disconnection/reconnection parameters (page code = 2) The following parameters are used to optimize the start timing of reconnection processing to transfer data on the SCSI bus at a read (READ or READ EXTENDED command) or write operation (WRITE, WRITE EXTENDED, or WRITE AND VERIFY command) of the disk. Refer to Chapter 2 "Data Buffer Management" of the SCSI Logical Interface Specifications for further details. • Buffer full ratio • Buffer empty ratio Parameter Default value 00 (HEX) 00 (HEX) Notes: 1. In a system without the disconnection function, these parameters need not be specified. 2. Determine the parameter values in consideration of the following performance factors of the system: • Time required for reconnection processing • Average data transfer rate of the SCSI bus • Average amount of processing data specified with a command Refer to Chapter 2 "Data Buffer Management" of the SCSI Logical Interface Specifications for how to obtain the rough calculation values for the parameter values to be set. It is recommended to evaluate the validity of the specified values by measuring performance in an operation status under the average system load requirements. C141-E270 91 Downloaded from www.Manualslib.com manuals search engine