Fujitsu S300M Getting Started Guide - Page 19
Connecting the ScanSnap, Connecting the cable
UPC - 097564307355
View all Fujitsu S300M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
2.2 Connecting the ScanSnap When the installation of the above programs is complete, connect the ScanSnap to your computer. ATTENTION Install ScanSnap Manager, and then restart your computer, before connecting the ScanSnap to your computer. ■ Connecting the cable Connect the ScanSnap to a power supply in either of two ways below: Power source Power outlet (When always operating the ScanSnap at the same regular place where it can be fed power from a power outlet) Use the following cable: Power cable The Power cable is a combination of the AC adapter and AC cable. See: "When connecting with the Power cable:" (page 19) Computer (When using the ScanSnap at a place where it reaches no power outlet, or when carrying the ScanSnap together with your laptop computer around and operating at a place where no power outlet is available) USB bus power cable "When connecting with the USB bus power cable:" (page 20) After connecting to a power source with the cable above, connect to your computer with a USB cable. CAUTION Use only the AC cable and AC adapter (power cable) below: Otherwise, a failure may be caused. • Manufacturer: LEI • Model No.: NU13-1072166-I3 18 ScanSnap S300M Getting Started