Fujitsu S300M Getting Started Guide - Page 34

Chapter 5 Daily Care This chapter describes how to clean the ScanSnap. WARNING • Before you clean the ScanSnap, unplug the power cable from the power outlet, or the USB bus power cable from the computer to prevent from fire or electric shock. • To avoid injuries, do not place the internal parts (such as the Pad ASSY and pick roller) in areas where small children can reach. 5.1 Cleaning Materials Cleaning Materials Cleaner F1 Cleaning wipe Parts No. PA03950-0352 PA03950-0419 Remarks 1 bottle (100 ml) (*1) 1 pack (24 sheets) (*2) *1) It may take long before the cleaner vaporizes if a large quantity is used. When cleaning the ScanSnap parts, dampen a cloth with modest quantities of the cleaner. In addition, wipe off the cleaner completely with a soft lint-free cloth to leave no residue on the surface of the cleaned parts. *2) Pre-moistened with Cleaner F1, Cleaning Wipes are used instead of moistened cloths. To purchase the cleaning material, contact the store where you purchased the ScanSnap or an authorized FUJITSU scanner service provider. 5.2 Cleaning the ScanSnap Exterior Clean the ScanSnap exterior with a cloth moistened with a small amount of neutral detergent or Cleaner F1 (sold separately). ATTENTION • Never use paint thinner or other organic solvents. • During the cleaning, prevent water or moisture from getting inside the ScanSnap. • Do not use aerosol sprays to clean the ScanSnap. Aerosol sprays cause dirt and dust to enter the ScanSnap, resulting in the ScanSnap failure or malfunction, or errors in scanned images. Cloth Cleaner F1 or neutral detergent Paint thinner 33