Fujitsu S300M Getting Started Guide - Page 21
When connecting with the USB bus power cable
UPC - 097564307355
View all Fujitsu S300M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
ATTENTION • Be sure to use the supplied AC adapter and AC cable. • Be sure to use the supplied USB cable. The operation with any commercially available USB cable is not guaranteed. • If only the USB cable is used, the ScanSnap does not operate. Be sure to use two types of cables, Power and USB cables, to connect the ScanSnap to your computer. • When connecting to a USB hub, be sure to use the first stage USB hub that is closest to the computer. If you use the second or later hub stages, the ScanSnap may not operate properly. • When connecting with a USB 2.0 cable, make sure that the USB port to connect to and hub must be USB 2.0-compliant. Note that if connected with a USB 1.1 cable, the scanning speed may become slow. When a USB 2.0-compliant port is available, it is recommended that the USB 2.0-compliant port be used. •When connecting with the USB bus power cable: Use the USB bus power cable and USB cable . 1. Connect the USB bus power cable. Remove the adhesive label covering the USB and power connectors Connect to the ScanSnap's power connector and your computer. 2. Connect the USB cable. Connect the USB cable to both the ScanSnap and your computer. USB connector Power connector Computer USB port 3. After power and USB ports are connected with cables, perform the procedure described in "Turning the ScanSnap ON" (page 21). 20 ScanSnap S300M Getting Started