GE 45600 User Manual - Page 5

4 from your remote control. NOTE: If the red LED emits one long, steady blink, you have pressed an invalid key or the device has not been successfully removed from your remote control. Repeat steps 1-5 if this occurs. DELETING A DEVICE (LIGHT / NODE) FROM YOUR NETWORK To reset a device to its factory default, you must delete it from the network. To delete the device from your network, perform the following steps: 1. Press and hold SETUP until both the red and green LEDs blink twice. 2. Press DELETE once. (Red LED blinks once) 3. Press LIGHT once. (Green LED blinks rapidly) 4. Press and release the button on the device so that it sends its information to the remote and receives information from the remote. 5. When the green LED blinks twice, you have successfully deleted the device from your home network. NOTE: If the red LED emits one long, steady blink, you have pressed an invalid key or the device has not been successfully deleted from your home network. Repeat steps 1-5 if this occurs. CONTROLLING INDIVIDUAL LIGHTS (DEVICES / NODES) You can control a light to turn on or off, or change its brightness level. The operation of a specific device varies by product. Refer to the manual for that device to learn its specific operation. 1. Press and release the LIGHT key to put the remote into "Individual Light Control" mode. (Red LED blinks once) The remote will stay in this mode until either the Group or Scene mode is activated. 2. Select the light you want to control. (Press and release SHIFT to control lights 10 through 18.) Turning a Light On or Off • To turn a light on, press and release the ON key for less than one second. The green LED will blink once. • To turn a light off, press and release the OFF key for less than one second. The green LED will blink once. Setting a Light's Brightness Level • To make a light brighter, press and hold the ON key for more than one second. (Green LED blinks rapidly)