GE CGS980SEMSS Use and Care Manual - Page 53
Consumer Support, Installation, Instructions, Operating Instructions, Safety Instructions
UPC - 084691163626
View all GE CGS980SEMSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Safety Instructions Operating Instructions GEAppliances.com Problem Excessive smoking Possible Causes Excessive soil. What To Do • Touch the CLEAR/OFF pad. Open the windows to rid the room of smoke. Wait until the LOCKED DOOR light goes off. Wipe up the excess soil and reset the clean cycle. Oven door will not open Oven too hot. after a clean cycle • Allow the oven to cool below locking temperature. Oven not clean after a clean cycle Oven controls not properly set. Oven was heavily soiled. • See the Using the self-cleaning upper oven section. • Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to self-clean again or for a longer period of time. "LOCK DOOR" flashes in the display LOCKED DOOR light is on when you want to cook The self-clean cycle has been selected but the door is not closed. The oven door is locked because the temperature inside the oven has not dropped below the locking temperature. • Close the oven door. • Touch the CLEAR/OFF pad. Allow the oven to cool. "F-and a number or You have a function error code. letter" flash in the display If the function code repeats. • Touch the CLEAR/OFF pad. Allow the oven to cool for one hour. Put the oven back into operation. • Disconnect all power to the range for 5 minutes and then reconnect power. If the function error code repeats, call for service. Oven racks are difficult to slide The gray porcelain-coated racks were improperly cleaned. • Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven racks with the paper towel. Do not spray with Pam® or other lubricant sprays. "Probe" appears in the display This is reminding you to enter a • Enter a probe temperature. probe temperature after plugging in the probe. LOC appears in the display The Gas/Control Lockout feature • Be sure the surface burner controls are turned OFF. is activated. Turn this feature off to use the range. See the Gas/Control Lockout section. Installation Instructions Troubleshooting Tips Consumer Support 53