GE CSB9120SJSS Installation Instructions - Page 11
Installation over a GE/Monogram Oven and, Warming Drawer, Installation over a GE/Monogram Oven
View all GE CSB9120SJSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE 36-3/4s. MODEL ZSC1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING (cont.) Installation over a GE/Monogram Oven: 30s 23-1/2s Construct Solid 25-1/4s Min.* Bottom Min. 3/8s Plywood Supported by 2 x 4 or 2 x 2 Runners all Four Sides 21s 2s Min. (3s Recommended) 36-3/4s Min. 45-1/4s Recommended* Per Oven Requirement *Required for Monogram models * For existing cutouts, a maximum width of 28-1/2s is acceptable. If the opening is slightly wider, secure a furring strip on each side of the cutout for securing the oven. • If you are replacing a GE/Monogram electric double oven with the combined installation of an Advantium 120V and a single oven, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 2s minimum shown. PREPARE THE OPENING (cont.) Installation over a GE/Monogram Oven and Warming Drawer: 30s 23-1/2s Construct Solid 25-1/4s Min.* Bottom Min. 3/8s Plywood Supported by 2 x 4 or 2 x 2 Runners all Four Sides 21s 2s Min. (3s Recommended) Per Oven Requirement 45-1/4s 2s Min. (3s Recommended) Per Warming Drawer Requirement * For existing cutouts, a maximum width of 28-1/2s is acceptable. If the opening is slightly wider, secure a furring strip on each side of the cutout for securing the oven. NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height. See Warming Drawer installation instructions for details. CAUTION: For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of this approximate 80-pound oven and 30-pound drawer, plus additional oven loads of up to 50 pounds or a total weight of 160 pounds. PRECAUCIÓN: Para seguridad personal, la superficie de montaje debe poder soportar la carga del gabinete, además del peso aproximado de 80 libras del horno y las 30 libras del cajón, más las cargas adicionales del horno de hasta 50 libras o un peso total de hasta 160 libras. 11