GE JVM1665SNSS Installation Instructions - Page 13
Preparation of Top Cabinet, Assemble and Install Adapter, Mount the Oven
UPC - 084691187387
View all GE JVM1665SNSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installation Instructions A2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adapter. A4. MOUNT THE OVEN • Read the instructions on the top cabinet template. • Tape it underneath the top cabinet. • Drill the holes, following the instructions on the top cabinet template. CAUTION: Wear safety goggles when drilling holes in the cabinet bottom. A3. ASSEMBLE AND INSTALL ADAPTER Damper Exhaust Adapter Blower Plate Back of Oven FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from over tightening screws. NOTE: When mounting the oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift oven, tilt it forward and hook slots at back bottom edge onto two lower tabs of mounting plate. NOTE: On some models, the exhaust adapter and damper assembly may already be assembled to the oven. 1 Place the oven in its upright position, with the top of the unit facing up. NOTE: Make sure the blower fan blades are visible and are pointing up. 2 Insert the tabs on each side of the damper into the holes at the inside rear of the adapter. 3 Attach the exhaust adapter to the blower plate with the two bronze metal screws provided. Make sure that the damper pivots easily before mounting oven. You will need to make adjustments to assure proper alignment with your house exhaust duct after the oven is installed. 2 Rotate front of oven up against cabinet bottom. 13