GE JVM1665SNSS Installation Instructions - Page 21
Mount the Oven, IMPORTANT: If filler blocks are not used
UPC - 084691187387
View all GE JVM1665SNSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Installation Instructions C3. ADAPTING BLOWER FOR RECIRCULATION (continued) 5 Place the blower unit back into the opening. CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. NOTE: When mounting the oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift oven, tilt it forward and hook slots at back bottom edge onto two lower tabs of mounting plate. 6 Replace blower plate and replace screws for blower plate and blower motor removed in Step 1. Blower Plate Screws Blower Plate Back of Oven Blower Motor Screw C4. MOUNT THE OVEN FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from over tightening screws. 2 Rotate front of oven up against cabinet bottom. Cabinet Front Cabinet Bottom Shelf Filler Block Equivalent to Depth of Cabinet Recess Oven Top Self-Aligning Screw 21