GE JVM1665SNSS Installation Instructions - Page 7
Tools You Will Need, Mounting Space - manual
UPC - 084691187387
View all GE JVM1665SNSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Installation Instructions TOOLS YOU WILL NEED # 1 and #2 Phillips screwdriver Pencil Ruler or tape measure and straight edge Carpenter square (optional) Tin snips (for cutting damper, if required) Gloves Scissors (to cut template, if necessary) Saw (saber, hole or keyhole) Electric drill with 3⁄16″, 7⁄16″, 3⁄8″, 1⁄2″ and 5⁄8″ drill bits Stud finder or Hammer (optional) Filler blocks or scrap wood pieces, if needed for top cabinet spacing (used on recessed bottom cabinet installations only) Safety goggles Level Duct and masking tape MOUNTING SPACE NOTE: Maximum cabinet depth is 13". 16-1⁄4″ 30″ 2″ 66″ or more from the floor to the top of the oven Bottom edge of cabinet needs to be 30″ or more from the cooking surface 30″ min. Backsplash NOTES: • The space between the cabinets must be 30″ wide and free of obstructions. • If the space between the cabinets is greater than 30″, a Filler Panel Kit may be used to fill in the gap between the oven and the cabinets. Your Owner's Manual contains the kit number for your model. • This oven is for installation over ranges up to 36″ wide. • If you are going to vent your oven to the outside, see Hood Exhaust Section for exhaust duct preparation. • When installing the oven beneath smooth, flat cabinets, be careful to follow the instructions on the top cabinet template for power cord clearance. 7