GE PW9000SFSS Use and Care Manual - Page 12

Installation of the warming drawer. Read these instructions completely and carefully. Remove Packaging and Parts Parts provided: 4 Wood screws Place carton on a flat surface. Open one end of the carton and lift off the top piece. Lift the warming drawer up and out of the carton. Place the drawer on top of the shipping carton to protect the drawer front and the finished flooring. Remove all packing materials and tape. Locate package containing 4 wood screws and set aside. Installation Below a Countertop Install 2x4 or 2x2 anti-tip block against rear cabinet wall 9" from floor to bottom of block Electrical outlet flush with side of cabinet 7" max. Electrical outlet 42" max. from right side 25" 7" Install a solid barrier below a cooktop (see Note) 9" Electrical outlet 16" max. from left side Solid barrier 1" Min.* 91ø4" 11ø2" Cabinet top 36" Countertop height 231ø2" Min. 1/4" Air gap Dimension A 27 " Drawer 30 " Drawer 25 1ø2" 28 1ø2" CAUTION IN CANADA THIS DRAWER IS NOT APPROVED FOR INSTALLATION UNDER A COOKTOP. Install a solid barrier and a 1/4" min. air gap above warming drawer *NOTE: When installing the warming drawer below a cooktop, a solid barrier must be installed at least 1"from the lowest point of the bottom of cooktop burner box to the top of cutout. Use any solid material such as 1/4" thick plywood. Allow at least 1/4"air gap between the barrier and the top of the warming drawer. See label on top of the wa rming drawer for approved cooktop models. „ When installed, the front face of the warming drawer will be nearly flush with cabinetry doors or drawer fronts. „ Drawer overlaps will conceal cut edges on all sides of the opening. The rough opening for the drawer must be: ³'HSWK 231ø2" minimum from inside back to front of cabinet frame. ³:LGWK 251ø2" for 27" wide models 281ø2" for 30" wide models. ³+HLJKW 91ø4" „ 5" minimum above floor or 1" above toekick. 231ø4" from floor to bottom of cutout is recommended for under countertop installation. Installation below a cabinet drawer: The warming drawer may be installed beneath a cabinet drawer. In this installation, a solid barrier should be installed above the warming drawer to block access. Use any solid material such as 1/4" thick plywood. Allow at least 1/4" air gap between the barrier and the top of the warming drawer. Observe the 5" min. above the floor or 1" above the toekick min. installation height. NOTE: If you are installing in frameless cabinets, it may be necessary to install 1/2" wide cleats to accept drawer mounting screws. See drawer to find exact locations of mounting screws. When installed under a cooktop: Warming drawers are suitable for installation below only certain specified cooktop models. See the label attached to the top of the warming drawer for suitable models. A solid barrier and air gap between cooktop and warming drawer is required. See Note above. 12