GE PW9000SFSS Use and Care Manual - Page 13

Installation Below Wall Ovens

Page 13 highlights

Read these instructions completely and carefully. GEAppliances.com Installation Below Wall Ovens Installation below a single oven 231ø2" Min. 2x2 or 2x4 anti-tip block against rear wall 9" from floor to bottom of block CAUTION Oven cutout 9" 91ø4" 2" Min. Allow 5/8" overlap on all sides 231ø4" NOTE: Additional clearance between cutouts may be required. Check to be sure that oven supports above the warming drawer location do not obstruct the required interior 231ø2" depth and 91ø4" height. IN CANADA, THE WALL OVEN IS ONLY APPROVED FOR INSTALLATION WITH A BOTTOM CUTOUT AT A MINIMUM OF 32.5" FROM THE FLOOR. A 1" Min. above toekick or adjust to oven installation height 10 1ø2" B Dimension A 27 " Drawer 25 1ø2" Dimension B 26 3ø4" Installation below a double oven  30 " Drawer 28 1ø2" 29 3ø4" 231ø2" Min. Oven cutout 2x2 or 2x4 antitip block against rear wall 9" from floor to bottom of block 9" 91ø4" A 1" Min. above toekick Allow 5/8" overlap on all sides 2" Min 231ø4" 10 1ø2" NOTE: Additional clearance between cutouts may be required. Check to be sure that oven supports above the warming drawer location do not obstruct the required interior 231ø2" depth and 91ø4" height. CAUTION IN CANADA, THIS DRAWER IS NOT APPROVED FOR INSTALLATION UNDER A DOUBLE OVEN. B „ When installed, the front face of the warming drawer will be nearly flush with cabinetry doors or drawer fronts. „ Drawer overlaps will conceal cut edges on all sides of the opening. NOTE: If you are installing in frameless cabinets, it may be necessary to install 1/2" wide cleats to accept drawer mounting screws. See drawer to find exact locations of mounting screws. When installed under a wall oven: The rough opening for the drawer must be: ³'HSWK 231ø2" minimum from inside back to front of cabinet frame. ³:LGWK 251ø2" for 27" wide models 281ø2" for 30" wide models. ³+HLJKW 91ø4" Warming drawers are suitable for installation below only certain specified wall oven models. See the label attached to the top of the warming drawer for suitable models. NOTE: Electrical receptacle can be installed as shown for countertop installations. Do not install receptacle above the top of the warming drawer cutout. ³$OORZPLQLPXPEHWZHHQRYHQDQGGUDZHUFXWRXWV for clearance of overlaps. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

13
When installed, the front face of the warming drawer
will be nearly flush with cabinetry doors or drawer
fronts.
Drawer overlaps will conceal cut edges on all sides of
the opening.
The rough opening for the drawer must be:
23
1
2
” minimum from inside back to front of
cabinet frame.
25
1
2
” for 27" wide models
28
1
2
” for 30" wide models.
9
1
4
for clearance of overlaps.
NOTE:
If you are installing in frameless cabinets, it may
be necessary to install 1/2" wide cleats to accept drawer
mounting screws. See drawer to find exact locations of
mounting screws.
When installed under a wall oven:
Warming drawers are suitable for installation below
only certain specified wall oven models. See the label
attached to the top of the warming drawer for suitable
models.
NOTE:
Electrical receptacle can be installed as shown for
countertop installations. Do not install receptacle above
the top of the warming drawer cutout.
23
1
2
Min.
2x2 or 2x4
anti-tip block
against rear
wall 9” from
floor to bottom
of block
1" Min. above toekick or
adjust to oven installation
height
A
NOTE:
Additional clearance between cutouts
may be required. Check to be sure that oven
supports above the warming drawer location
do not obstruct the required interior 23
1
2
depth and 9
1
4
” height.
Installation below a single oven
NOTE:
Additional clearance between cutouts
may be required. Check to be sure that oven
supports above the warming drawer location
do not obstruct the required interior 23
1
2
depth and 9
1
4
” height.
Installation below a double oven
2" Min.
Allow 5/8”
overlap on
all sides
10
1
2
23
1
4
Installation Below Wall Ovens
GEAppliances.com
Read these instructions completely and carefully.
9"
9
1
4
B
Oven
cutout
2" Min
1" Min. above
toekick
2x2 or 2x4 anti-
tip block against
rear wall 9” from
floor to bottom
of block
23
1
2
Min.
Allow 5/8” overlap
on all sides
A
23
1
4
10
1
2
9"
9
1
4
Oven
cutout
B
IN CANADA, THIS DRAWER IS NOT APPROVED
FOR INSTALLATION UNDER A DOUBLE OVEN.
Dimension A
Dimension B
27 " Drawer
25
1
2
26
3
4
30 " Drawer
28
1
2
29
3
4
"
IN
CANADA,
THE
WALL
OVEN IS ONLY APPROVED
FOR INSTALLATION WITH
A BOTTOM CUTOUT AT A
MINIMUM OF 32.5” FROM
THE FLOOR.
CAUTION
CAUTION