GE PW9000SFSS Use and Care Manual - Page 14

Installation of the warming drawer. Read these instructions completely and carefully. Provide Cabinet Support 2" x 4" or equivalent runners 2" x 4" or equivalent runners 231ø2" 231ø2" 22" 25" 27" 30" IMPORTANT: When installed below a single or double oven, check to be sure that any oven supports above the cutout do not obstruct the 231ø2" required depth of the warming drawer cutout. „ A 2" minimum clearance between oven and warming drawer cutouts are required. Additional clearance may be required if 2 x 4 blocks are used to support runners or solid floor of the oven above. „ The warming drawer may be supported by either a solid bottom, 2 x 4 or 2 x 2 runners. „ The support must be level and rigidly mounted, flush with the bottom edge of the cutout. „ There is no way to level the drawer once it has been installed. Be sure supports are level. „ The entire weight of the drawer is supported by the runners or solid floor and must be capable of supporting 150 lbs. 6WHS³,QVWDOO$QWL7LS%UDFH WARNING: ANTI-TIP PRECAUTIONS: The anti-tip brace must be installed to prevent the drawer from tipping forward when opened and loaded. Failure to do so could result in personal injury. Install 2x4 or 2x2 anti-tip brace against rear cabinet wall 9" from floor to bottom of brace 9" 2x4 or 2x2 runners or solid bottom 14