GE RVM1535MMSA Installation Instructions - Page 17
ADAPTING MICROWAVE, BLOWER FOR OUTSIDE, BACK EXHAUST cont., CAUTION: Do not pull or stretch the blower
UPC - 084691156598
View all GE RVM1535MMSA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installation Instructions B4. ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST (cont.) 3 Carefully slide the blower motor toward the right, and lift it partially out of the opening. Note: The blower wires are long enough to allow flexible handling while performing these steps. Disconnect the wires only if it is necessary for additional flexibility. Back of Microwave 4 Remove the two screws holding the gray-colored inlet sleeve to the blower unit. Rotate the gray sleeve as shown until the gray arrow lines up with the "B", back exhaust. Reinstall the two screws. Remove screws from Gray Inlet Sleeve Back of Microwave 5 Roll the assembled blower unit so that the black-colored exhaust outlet faces the back of the microwave and the gray-colored inlet sleeve faces downward. NOTE: The gray-colored sleeve opening must ALWAYS face downward to ensure proper operation of the microwave. Black Exhaust Outlet Must Face Downward Back of Microwave 6 Tilt and place the blower unit back into the opening in the top of the microwave. CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. 7 Secure the blower unit to the microwave with the two screws removed in Step 2. Retaining screw Retaining screw 8 Close the blower cover. 9 Attach the exhaust adaptor to the rear of the microwave by sliding it into the guides at the top center of the back of the oven. Adaptor Back of Microwave Guide Guide Blower Motor Screw Locking Tabs Push in securely until it is in the lower locking tabs. Take care to assure that the damper hinge is installed so that it is at the top and that the damper swings freely. Reinstall the original blower motor screw through the adaptor and into the back of the microwave. 17