GE RVM1535MMSA Installation Instructions - Page 20
Adapting Microwave Blower for Recirculation, blower wires are long enough to allow flexible
UPC - 084691156598
View all GE RVM1535MMSA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installation Instructions C3. ADAPTING MICROWAVE BLOWER FOR RECIRCULATION 1 Remove the back top center blower motor door retaining screw. Blower Motor Back of Microwave 3 Carefully slide the blower motor toward the right, and lift it partially out of the opening. Note: The blower wires are long enough to allow flexible handling while performing these steps. Disconnect the wires only if it is necessary for additional flexibility. Blower Door Screw 2 Open the blower door by lifting it up at the back side of the microwave. Remove and save the top and back retaining screws that hold the blower motor in the microwave. Retaining screw Retaining screw Back of Microwave 4 Remove the two screws holding the gray colored inlet sleeve to the blower unit. Rotate the gray sleeve as shown until the gray arrow lines up with the "R", Recirculating exhaust. Reinstall the two screws. Remove screws from Gray Inlet Sleeve Back of Microwave 5 Roll the assembled blower unit so that the black-colored exhaust outlet faces the front of the microwave and the gray-colored inlet sleeve faces downward. NOTE: The gray-colored sleeve opening must ALWAYS face downward to ensure proper operation of the microwave. Must Face Downward Black Exhaust Outlet Facing the Front Back of Microwave 20