GE RVM1535MMSA Installation Instructions - Page 21

Installation Instructions C3. ADAPTING MICROWAVE BLOWER FOR RECIRCULATION (cont.) 6 Tilt and place the blower unit back into the opening in the top of the microwave. NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift microwave, tilt it forward and hook slots at back bottom edge onto four lower tabs of mounting plate. CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. 7 Secure the blower unit to the microwave with the two screws removed in Step 2. Retaining screw Retaining screw 8 Close the blower cover and secure it with the screw removed in Step 1. C4. MOUNT THE MICROWAVE OVEN 2 Rotate front of oven up against cabinet bottom. 3 Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet. Cabinet Front Cabinet Bottom Shelf Filler Block Equivalent to Depth of Cabinet Recess Self-Aligning Screw Microwave Oven Top FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from overtightening screws. 21