GE WNRD2050GWC Installation Instructions - Page 2
Installation Preparation - washer
View all GE WNRD2050GWC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Installation Preparation TOOLS YOU WILL NEED • Socket set • Slip joint pliers INSTALLATION REQUIREMENTS: LOCATION Washer must be installed on firm flooring to minimize vibration during spin cycles. Concrete flooring is best, but wood base is sufficient provided that floor support meets FHA standards. Washer should not be installed on rugs or carpet, be exposed to weather or temperatures below freezing. PLUMBING • Water Pressure-Must be 20 psi minimum to 150 psi maximum dynamic pressure measured at faucet. • Water Temperature-Water heater should be set to deliver water at 120°F to 150°F (50°C to 66°C) IN THE WASHER when HOT wash is selected. • Shutoff Valves-Both hot and cold shutoff valves (faucets) should be supplied. • Drain-Water may be drained into a standpipe or set tub. The discharge height MUST NOT BE LESS THAN 30 INCHES nor more than 6 feet above the base of the washer. The standpipe must be 1-1/2 inches minimum inside diameter and must be open to the atmosphere. PREPARE ELECTRICAL WIRING WARNING FOR PERSONAL SAFETY: • FOR PERSONAL SAFETY DO NOT USE AN EXTENSION CORD OR ADAPTOR PLUG WITH THIS APPLIANCE. • DO NOT, UNDER ANY CIRCUMSTANCE, CUT OR REMOVE THE THIRD GROUNDING PRONG FROM THE POWER CORD. • FOLLOW NATIONAL ELECTRIC CODE ANSI/NFPA 70 OR LOCAL CODES AND ORDINANCES. ELECTRICAL PREPARATION This appliance must be supplied with 115V, 60 Hz, and connected to an individual, properly grounded branch circuit, protected by a 15 or 20 amp circuit breaker or fuse. • If the electric supply provided does not meet the above specifications, call a licensed electrician. Insure Proper Ground Exists Before Use GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electrical current. This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Attach Ground (Obtain Locally) If required, an external ground wire (not provided) which meets local codes may be added. Attach to washer cabinet with sheet metal screws (not provided) to rear of washer as illustrated. The screw required is a #8 sheet metal screw, 18 threads per inch, 1/2 inch long. It can be obtained locally at any hardware store. WARNING Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician if you are in doubt as to whether the appliance is properly grounded. #282 French 2