GE GTWN7450DWW Use and Care Manual - Page 3
Save These Instructions - warranty
View all GE GTWN7450DWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
GEAppliances.com PROPER INSTALLATION This washer must be properly installed and located in accordance with the Installation Instructions before it is used. If you did not receive an Installation Instructions, you can receive one by visiting GEAppliances.com or by calling 800.GE.CARES (800.432.2737). Ensure that the hot water hose is connected to the "H" Parts and Accessories (internal red screened) valve and the cold water hose is connected to the "C" (internal blue screened) valve. Install or store where it will not be exposed to Order on-line at GEApplianceparts.com today, 24 hours a day or by phone at 800.626.2002 during normal business hours. temperatures below freezing or exposed to the weather, which could cause permanent damage and invalidate the Part Number Accessory warranty. PM14X10002 4 ft Rubber Water Supply Hoses Properly ground washer to conform with all governing codes and ordinances. Follow details Or PM14X10005 4 ft Braided Water Supply Hoses in Installation Instructions. WX10X10011 Tide® Washing Machine Cleaner* This washer does not include water supply hoses. WX7X1 Washer Floor Tray GE strongly recommends the use of factory specified parts. A list of factory hoses available for purchase are listed below. These hoses are manufactured and tested to meet GE specifications. DR07X10002 DRM2E300V0 6' Cable ACM, Splitter, two 6' Cables & a 1' Cable GE strongly recommends the use of new water supply hoses. Hoses degrade over time and need to be replaced every 5 years to reduce the risk of hose failures and water damage. ¥ FUNCTIONALITY CHECK WARNING DO NOT allow children to play on or in this appliance. Close supervision of children is necessary when this appliance is used near children. Failure to follow this instruction may result in death or injury to persons. Confined Space Hazard If the lid is opened between cycles (i.e. not pausing and restarting the current cycle, changing cycles after it started, etc.) pushing the Start button will cause the washer to turn on the cold water for 5 seconds followed by a 10 second delay before locking the lid and starting the cycle. WHEN NOT IN USE Turn off water faucets to minimize leakage if a break or rupture should occur. Check the condition of the fill hoses; GE recommends changing the hoses every 5 years. If the lid is opened during this 15 second period, the word PAUSE will start scrolling across its display. You will have to push the Start button again to restart the cycle. * Tide® is a registered trademark of Procter & Gamble SAVE THESE INSTRUCTIONS 3