GE PTS25SHS Use and Care Manual - Page 8

Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions About the shelves and bins. Slide-Out Spillproof Shelf (on some models) The slide-out spillproof shelf allows you to reach items stored behind others. The special edges are designed to help prevent spills from dripping to lower shelves. To remove: Remove all items from shelf. Slide the shelf out until it stops. Lift the front edge of the shelf until the central tabs are above the front bar. Continue pulling the shelf forward until it can be removed. To replace: Place the rear shelf tabs just in front of the central notches on the shelf frame. Slide the shelf in until the central tabs are slightly behind the front bar. Lower the shelf into place until it is horizontal and slide the shelf in. Make sure that the shelf sits flat after reinstallation and doesn't move freely from side to side. Make sure you push the shelves all the way in before you close the door. Finger hold Snugger Adjustable Bins on the Door Adjustable bins can easily be carried from refrigerator to work area. To remove: Lift bin straight up, then pull out. To replace or relocate: Engage the bin in the molded supports of the door, and push in. Bin will lock in place. The snugger helps prevent tipping, spilling or sliding of small items stored on the door shelf. Grip the finger hold near the rear of the snugger and move it to fit your needs. Non-Adjustable Shelves on the Door To remove: Lift the shelf straight up, then pull out. To replace: Engage the shelf in the molded supports on the door and push down. It will lock in place. Freezer Tilt Out Bin (on some models) Push the button as you tilt out the bin. To remove: Hold the sides of the bin and lift it straight up, then pull out. To replace: Engage the ends of the bin in the molded supports on the door and push down. It will lock in place. NOTE: Do not overload the bin. Consumer Support 8