Gigabyte GA-EX58-UD5 Manual - Page 62
Controller 0 GSATA2 0/1/ Controller 1 GSATA2 2/3, Smart Backup
UPC - 818313006837
View all Gigabyte GA-EX58-UD5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Smart Backup CMOS Setup Utility-Copyright (C) 1984-2008 Award Software Smart Backup Controller 0 (GSATA2 0/1) Controller 1 (GSATA2 2/3) [Press Enter] [Press Enter] Item Help Menu Level Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults The Controller 0 (GSATA2 0/1)/Controller 1 (GSATA2 2/3) submenu allows you to check the information of the hard drive(s) connected to the GSATA2_0~3 connectors or to configure a RAID array. The Controller 0 (GSATA2 0/1) supports the GSATA2_0 and GSATA2_1 connectors and the Controller 1 (GSATA2 2/3) supports the GSATA2_2 and GSATA2_3 connectors. After the configuration, ensure the SATA controller driver has been installed in the operating system. You can install the Smart Backup utility (refer to Chapter 5, "Configuring SA TA Hard Drive(s)," to view the device status in the operating system. Controller 0 (GSATA2 0/1)/ Controller 1 (GSATA2 2/3) CMOS Setup Utility-Copyright (C) 1984-2008 Award Software Controller 0 (GSATA2 0/1) Disk/RAID Status Smart Backup Config [Press Enter] [Press Enter] Item Help Menu Level Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults GA-EX58-UD5P/UD5 Motherboard - 62 -