Gigabyte GA-P55A-UD7 Manual - Page 57

Onboard LAN1/LAN2 Boot ROM Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip. (Default: Disabled) Onboard USB 3.0 Controller (NEC USB 3.0 Controller) Enables or disables the USB 3.0 controller integrated in the NEC chip. (Default: Enabled) eSATA Controller (JMicron JMB362 Chip, eSATA Connectors on the Back Panel) Enables or disables the SATA controller integrated in the JMicron JMB362 chip. (Default: Enabled) eSATA Ctrl Mode (JMicron JMB362 Chip, eSATA Connectors on the Back Panel) Enables or disables RAID for the SATA controller integrated in the JMicron JMB362 chip or configures the SATA controller to AHCI mode. IDE Disables RAID for the SATA controller and configures the SATA controller to IDE mode. (Default) AHCI Configures the SATA controller to AHCI mode. Advanced Host Controller Interface (AHCI) is an interface specification that allows the storage driver to enable advanced Serial ATA features such as Native Command Queuing and hot plug. RAID Enables RAID for the SATA controller. GSATA 6_7/IDE Controller (GIGABYTE SATA2 Chip, IDE and GSATA2_6/7 Connectors) Enables or disables the IDE and SATA controller integrated in the GIGABYTE SATA2 chip. (Default: Enabled) GSATA 6_7/IDE Ctrl Mode (GIGABYTE SATA2 Chip, GSATA2_6/7 Connectors) Enables or disables RAID for the SATA controller integrated in the GIGABYTE SATA2 chip or configures the SATA controller to AHCI mode. IDE Configures the SATA controller to IDE mode. (Default) AHCI Configures the SATA controller to AHCI mode. Advanced Host Controller Interface (AHCI) is an interface specification that allows the storage driver to enable advanced Serial ATA features such as Native Command Queuing and hot plug. RAID/IDE Enables RAID for the SATA controller; the IDE controller still operates in IDE mode. GSATA 8_9/IDE Controller (Marvell 9128 Chip, GSATA3_8/9 Connectors) Enables or disables the SATA controller integrated in the Marvell 9128 chip. (Default: Enabled) GSATA 8_9/IDE Ctrl Mode (Marvell 9128 Chip, GSATA3_8/9 Connectors) Allows you to decide whether to configure the SATA controller integrated in the Marvell 9128 chip to AHCI mode. IDE Configures the SATA controller to IDE mode. (Default) AHCI Configures the SATA controller to AHCI mode. Advanced Host Controller Interface (AHCI) is an interface specification that allows the storage driver to enable advanced Serial ATA features such as Native Command Queuing and hot plug. GSATA RAID Configuration (Marvell 9128 Chip, GSATA3_8/9 Connectors) Allows you to configure RAID for the Marvell 9128 SATA controller. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. Onboard Serial Port 1 Enables or disables the first serial port and specifies its base I/O address and corresponding interrupt. Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled. - 57 - BIOS Setup