Gigabyte GA-X48-DS4 Manual - Page 51

2-9 MB Intelligent Tweaker(M.I.T.) CMOS Setup Utility-Copyright (C) 1984-2008 Award Software MB Intelligent Tweaker(M.I.T.) Robust Graphics Booster CPU Clock Ratio (Note) Fine CPU Clock Ratio (Note) CPU Frequency CPU Host Clock Control x CPU Host Frequency (Mhz) PCI Express Frequency (Mhz) C.I.A. 2 Performance Enhance System Memory Multiplier Memory Frequency (Mhz) (SPD) 800 DRAM Timing Selectable (SPD) ******** Standard Timing Control ******** x CAS Latency Time 4 x DRAM RAS# to CAS# Delay 4 x DRAM RAS# Precharge 4 x Precharge delay(tRAS) 11 ******** Advanced Timing Control ******** x ACT to ACT Delay(tRRD) 2 [Auto] [7X] [+0.5] 2.50GHz(333x7.5) [Disabled] 333 [Auto] [Disabled] [Turbo] [Auto] 800 [Auto] Auto Auto Auto Auto Auto Item Help Menu Level` KLJI: Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults CMOS Setup Utility-Copyright (C) 1984-2008 Award Software MB Intelligent Tweaker(M.I.T.) x Rank Write to READ Delay 2 Auto x Write To Precharge Delay 4 Auto x Refresh to ACT Delay 28 Auto x Read to Precharge Delay 2 Auto x Static tRead Value 4 Auto x Static tRead Phase Adjust 0 Auto x Command Rate (CMD) 2 Auto ******** Clock Driving & Skew Control ******** CPU/PCIEX Clock Driving Control [800mV] CPU Clock Skew Control [Normal] (G)MCH Clock Skew Control [Normal] ******** System Voltage Optimized ******** System Voltage Control [Manual] DDR2 OverVoltage Control [Normal] PCI-E OverVoltage Control [Normal] FSB OverVoltage Control [Normal] (G)MCH OverVoltage Control [Normal] Loadline Calibration [Auto] CPU Voltage Control [Normal] Normal CPU Vcore 1.37500V Item Help Menu Level` KLJI: Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults • Incorrectly doing overclock/overvoltage may result in damage to CPU, chipset, or memory and reduce the useful life of these components. This page is for advanced users only and we recommend you not to alter the default settings to prevent system instability or other unexpected results. (Inadequately altering the settings may result in system's failure to boot. If this occurs, clear the CMOS values and reset the board to default values.) • When the System Voltage Optimized item blinks in red, it is recommended that you set the System Voltage Control item to Auto to optimize the system voltage settings. (Note) This item appears only if you install a CPU that supports this feature. - 51 - BIOS Setup