Haier XQB50-20 User Manual - Page 18
Trouble-shooting, Answer to question - questions
View all Haier XQB50-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Trouble-shooting Answer to question (If there's a breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomena Reason The digital tube displays "E0" The top lid is not closed The draining does not work, or the speed of draining is too slow. The digital tube displays "E1" and it rings. It stops running during spin. The digital tube displays "E2" and it rings. Is the drain hose upended? Is the drain hose blocked by foreign material? The top lid is not closed The safety switch acts. The spinning cannot work (after twice revising). The digital tube displays "E3" and it rings. Are the laundries put slantingly? Is the machine slanting? How to settle Close the top lid Put down the drain hose.. Open and close the top lid once. Clean the foreign material. Open and close the top lid once. Close the top lid Re-order the laundries. Close the top lid. Level the machine in right position. Open and close the top lid once. It does not do water inlet or the speed is slow (the water level is not reached after 15 minutes). The digital tube displays "E4" and it rings. Is the water faucet open or is there water supply failure? Is the water inlet valve is blocked Is the water pressure too low? Open the water faucet. Open and close the top lid once. Clean the water inlet valve. Open and close the top lid once. Open and close the top lid once. The digital tube displays "E6". The water level sensor is failure. Not wash The machine does not act Not spin There's abnormal sound inside the machine Is there power failure? Is the power plug inserted tightly? Is the water level reached preset position? Is the power plug inserted tightly? Is the top lid closed reliably? Are the laundries set flat? Is the machine slanting? Are the laundries put slantingly in spinning? Are there any foreign materials? The water tap leaks Is the screw of the jointer of water inlet hose loose or awry? Common phenomena Phenomena Please contact the after-salesservice department. Please use it when there's power supply. Insert the power plug tightly. Fill water to the preset position. Is the power plug inserted tightly? Is the top lid closed reliably? Are the laundries set flat? Adjust the machine to be even Reorder the laundries and close the top lid. Remove the foreign materials. Fasten the screw of the jointer properly. Explanation The spinning is intermittent when it starts. Pause during washing. Select spin, but it doesn't work. The pulsator pauses during water inlet in wash and rinse. There may be some water flowing out of the drain hose in the first use of the machine. Balance the laundries to avoid slanting. supplemental water filled after fabric sensor has checked fabric (about 48 seconds) The program is setting the drain time. Some time is needed before it starts spinning. It is to avoid splashing during water inlet. It is the water remained in the factory inspection of performance.