Haier XQB50-20 User Manual - Page 6
How to change the direction of the drain hose
View all Haier XQB50-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Before Using How to change the direction of the drain hose 1 Loosen the fastening screws of the back cover,unpack the back cover gently, avoiding to break the clip claw. Figure 1 Back cover 3 Stretch out the drain hose to the right of the frame from the groove. Fasten it in the base frame with the drain hose support, and fasten the screws.Then hang the hook in the drain hose, and hang the drain hose in the hole of the cabinet. (Figure 3) ( Figure 3 ) 2 Take the drain hose from the cabinet, make the mouth of 4 Install the back cover. Hang the under side of the it flat a little, dismantle the pothook, loosen the fastening back cover on the cabinet firstly, then push the left screws, dismantle the drain hose support ,and pull the drain , the right tab and the upside into the cabinet. hose into the cabinet from the left of the base. Do not do it strongly, and fasten the screws. Figure 2 (Figure 4) Upper tab Drain hose frame Screws Screws Make the mouth of the ( Figure 2 ) drain hose flat, take off the pothook. Usage of the drain hose Side tab Lower hook (Figure 4) The drainage shall be smooth with the drain hose. 1.Never let the drain hose exceed 10cm above the ground. If the timeof draining is too long, the washing machine will stop in the midway. 2.Do not step on or press the drain hose. 4.If extra drain hose is needed, please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m. > 30mm