Harman Kardon AVP-2 Owners Manual - Page 6

0. 0 AVP2 BACK PANEL v:47,5:1 Manufactured under license from Dolby Laboratories Licensing Corporation. Additionally licensed under the following patents: U.S. 3,959,590, 4,932,059; Canada 1,004,603, 1,037,877 and patents pending of Jim Fosgate. Dolby and the double D symbol are trademarks of Dolby Laboratories Licensing Corporation. MADE IN THE U.S.A. harman/kardon 8380 Balboa Boulevard Northridge, CA 91325 S-Video 1 S-Vidco 2 Audio Source Input V V Aux 1 Aux 2 0 L 0 L 0 0 O OROR O OR OR O OR O 0 Record Out Line Outputs O A CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION: RISQUE DE CHOC FLFCIRKTUE-Nh PAS OUVRIR WARNING: TO wooer THE RISK OF FIRE OR Fi FCTRIC SI IOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN On MOISTURE This device complies with Part 15 of the F. rules. Operation subject to the following liff, conditions: MOTs device may not cause harmful interference and (2) Mis device must accept any interference received including interference that may cause Ufa.. operation. CAUTION: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY SAME TYPE 250mA, 250 VOLT FUSE ATTENTION: UN FUSIBLE DE RECHANGE DE MEME TYPE DE 250mA, 250 V VIDEO INPUTS VCR Aux 1 Video Output Source O O OUTPUT LEVEL ADJUSTMENTS LF CF RF RR LR SUB S-Inputs S-Outputs S-Video 1 S-Video 2 Source Record POWER CONS,NPTION 25W O Reme e I R. Sensor Optional SUB RR Do Not Force Adjustments as Damage May Result Record Outputs AVP2 AUDIO VIDEO INPUTS/OUTPUTS Audio Inputs All input jacks are grouped to the left hand side of the back panel as viewed from the backside of the AVP2. They are labeled S-Video 1, S-Video 2, VCR, VDP (Video Disc Player), Aux 1, and Aux 2. All six inputs accept input audio signals ranging in level from .25 volt to 3 volts. Audio Record Outputs This pair of output jacks located next to the audio input group, provides unprocessed stereo audio for a tape recorder or a second zone or room location. Audio Outputs This group of output jacks provides the appropriate signals to feed external power amplifiers driving the main front speakers for left, right, and center (LF, RF, CF) subwoofer(sub), and left and right rear speakers (LR, RR). Individual output level trim controls are located to the right of the audio output jacks. The trim controls can be finger adjusted. Exercise care when turning the trim controls; do not use excessive force or the control may be damaged. Video Inputs These composite video inputs are located just to the right of the audio output trim level controls. They are labeled to coincide with four audio inputs: VCR, VDP, Aux 1, Aux 2, Video Outputs This pair of composite video outputs located to the right of the video inputs provide composite video outputs to feed a video monitor or projector. The record output provides a separate audio feed for recording or a second room location. The video signal for the record output is selected by the Record Select button the front panel of the AVP2. S-Video Inputs S-Video 1 and S-Video 2 are located just to the right of the composite video outputs. S-Video 1 and S-Video 2 accept S-type video signals from S-type VCRs, laser disc players, and satellite television receivers. S-Video Outputs The S-Video outputs are located to the right of the S-Video inputs. The Source output feeds a video monitor or projector which accepts S-type video while the Record output feeds a VCR or second room location. CAUTION: We do not recommend running S-Video over cable lengths exceeding 15'. An optional switcher/RGB chroma decoder, the VC 3, is available from Harman Video. The VC 3 automatically selects S-type or composite video and transcodes it to RGB for feeding RGB-capable video projectors such as the Harman Models 3, 6, 8, and Data series 5