Harman Kardon AVR45 Owners Manual - Page 32

Programming the Remote

4. Press the

Device Control Selector

again, and note that the red light will

flash twice to confirm the entry before

going dark.

5. Try all of the functions on the

remote to make certain that the

product operates. Keep in mind that

many manufacturers use a number

of different combinations of codes,

and it is a good idea to make certain

that that not only the Power control

works, but the volume, channel and

transport controls, as appropriate. If

all functions do not work properly,

you may need to Auto-Search for a

different code, or enter a code via the

Direct Code Entry method.

Code Readout

When the code has been entered using the

Auto Search method, it is always a good

idea to find out the exact code so that it

may be easily reentered if necessary. You

may also read the codes to verify which

device has been programmed to a specific

Control Selector button.

1. Press and hold both the

Device

Control Selector

b

for the type

of product to be entered (e.g., VCR,

TV) and the

Mute

button

d

at the

same time. Hold both buttons until

the red light under the button stays

lit. Note that the next step must take

place while the red light is on, and it

must begin within 20 seconds after

the light illuminates.

2. Press the

Night

button

j

. The red

light under the

Device Control

Selector

b

will blink in a

sequence that corresponds to the

three-digit code, with a one-second

pause between each digit. Count the

number of blinks between each pause

to determine the digit of the code.

One blink is the number 1, two blinks

is the number 2, and so forth. Ten

blinks are used to indicate a “0”.

Example: One blink, followed by a one-

second pause, followed by six blinks, fol-

lowed by a one-second pause, followed by

ten blinks indicates that the code has

been set to 160.

For future reference enter the Setup Codes

for the equipment in your system here:

CD

TAPE

AUX

SAT

TV

VCR

CBL

Programmed Device Functions

Once the AVR45’s remote has been pro-

grammed for the codes of other devices,

press the appropriate

Device Control

Selector

b

to change the remote

from control over the AVR45 to the addi-

tional product. When you press any of the

Device Control Selectors

, it will

briefly flash in red to indicate that you

have changed the device being controlled.

When operating a device other than the

AVR45, the controls may not correspond

exactly to the function printed on the

remote or button. Some commands, such

as the volume control, are the same as

with the AVR45. Other buttons will

change their function so that they corre-

spond to a secondary label on the remote.

For example, the Sleep and Surround

Mode selector buttons also function as the

Channel Up and Channel Down buttons

when operating most TV sets, VCRs or

cable boxes. The Channel Up/Down indi-

cation is printed directly on the remote.

The same is true for standard CD player,

cassette deck, VCR and DVD functions,

which follow the standard function icons

printed on top of the buttons.

For some products, however, the function

of a particular button does not follow the

command printed on the remote. In

order to see which function a button con-

trols, consult the Function List tables

printed in this manual. To use those

tables, first check the type of device being

controlled (e.g., TV, VCR). Next, look at

the remote control diagram pictured on

the following page. Note that each button

has a number on it.

29

Harman Kardon AVR45 Owners Manual - Page 32

Code Readout, Programmed Device Functions

Page 32 highlights