Hayward OnCommand® Model: ALL MODELS Installation - Page 16
Base Station, Goldline Aqua Rite or Hayward Swimpure Chlorinator
View all Hayward OnCommand® manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Base Station Plug in the pigtail connector from the wireless base station into the "wireless" connector on the main PCB in the OnCommand control unit. Goldline Aqua Rite or Hayward Swimpure Chlorinator The OnCommand can control one or more Goldline Aqua Rite or Hayward Swimpure chlorinators when additional sanitizing capacity is required. A 4 wire connection is used to communicate to the Aqua Rite/Swimpure and can be wired up to 500' apart. Any outdoor rated 4 conductor cable can be used. Refer to the wiring diagrams below for proper wiring connection to the Aqua Rite/Swimpure. NOTE: There must be only 1 "primary" unit. All other Aqua Rite/Swimpure units must be configured as "secondary". Jumper Installed For Primary (Factory Default) 4 GREEN 3 YELLOW 2 BLACK 1 RED Jumper Removed For Secondary(s) Additional Aqua Rite/Swimpure(s) (if required) ONCOMMAND Aqua Rite or Swimpure (Primary) Aqua Rite or Swimpure (Secondary) NOTE: Primary/Secondary jumper is located underneath small circuit board. ONCOMMAND GRN 4 YEL 3 BLK 2 RED 1 green 4 GRN yellow 3 YEL Aqua Rite/ black 2 BLK Swimpure red 1 RED 13