HealthRider 250p Treadmill Uk Manual - Page 8

4. Insert a Handrail Extension (85) into the post on the left Upright (82). Align the holes in the Handrail Extension with the holes in the post. If necessary, tap the Handrail Extension with a rubber mallet to fully insert it. Next, attach the Handrail Extension by tightening three Short Screws (101) into the indicated holes. Note that the hole in the left side of the post is not used. Note: If there is only one hole in the top of the post, tighten the third Short Screw into the hole in the left side of the post. Identify the Left Handgrip (110), which has a large cutout in the right side. Slide the Left Handgrip as far as possible onto the Handrail Extension (85). It may be helpful to apply soapy water to the Handrail Extension. 5. Make sure that the front edge of the Left Handgrip (110) is under the Console Base (87) as shown. Tighten a Short Screw (101) into the side of the Left Handgrip as shown. Attach the Right Handgrip (not shown) and the other Handrail Extension (not shown) as described in step 4 and this step. Note: There may be extra screws left when assembly is completed. 4 Cutout 110 101 Post 85 101 82 101 5 87 101 110 101 6. See drawing 6a. Locate the left Rear Foot (59) on the treadmill. If the left Rear Foot touches the floor, go to step 7. If there is a space between the left Rear Foot and the floor, follow the instructions below. Hold the treadmill firmly with both hands, and raise the treadmill to the storage position as described on page 20. See drawing 6b. Using a phillips screwdriver, remove the Rear Foot Screw (60), the right Rear Foot (59), and the Rear Foot Spacer (120) from the treadmill. Reattach the right Rear Foot without the Rear Foot Spacer. Hold the treadmill with both hands, and lower the treadmill as described on page 19. Carefully lower the treadmill. If there is still a space between the left Rear Foot (not shown) and the floor, raise the treadmill and remove the left Rear Foot. Snap the Rear Foot Spacer (120) onto the left Rear Foot and reattach the left Rear Foot and the Rear Foot Spacer. 6a 59 6b 60 59 120 7. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet from damage, place a mat under the treadmill. 8