HealthRider H125t Treadmill Uk Manual - Page 10
If You Do Not Connect The Con
View all HealthRider H125t Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
9. With the help of a second person, hold the console assembly near the Left Upright (88). Route the Upright Wire (77) and the pulse wire from the Left Upright (88) around the indicated crossbar. Then, route the wires through the looped ties on the bottom of the console assembly. Connect the Upright Wire (77) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Connect the pulse wire in the console assembly to the pulse wire in the Left Upright (88). 9 Console Wire 77 Pulse Wires Console Wire 77 Console Assembly Crossbar Ties 88 10. S et the console assembly on the brackets on the Left and Right Uprights (88, not shown). Be careful not to pinch any wires. Attach the console assembly with four 5/16" x 1 1/4" Screws (4) and four 5/16" Star Washers (11) (only one side is shown). Start all four Screws, and then tighten them. Tighten the four 3/8" x 4 1/2" Screws (5) (only one side is shown). Insert the excess wires into the hole in the console assembly. Tighten the ties around the wires and cut off the ends of the ties. 10 Hole Console Assembly Bracket Ties 11 5 4 88 10