HealthRider H125t Treadmill Uk Manual - Page 7
See the inset drawing., Make sure that the power cord is unplugged., Attach the Right Wheel Cap
View all HealthRider H125t Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
1. Make sure that the power cord is unplugged. Place a piece of cardboard below the rear of the 1 Frame (57) to protect the floor or carpet. Attach the Left Wheel Cap (92) to the Base (91) with two #8 x 3/4" Screws (2). Attach the Right Wheel Cap (not shown) to the right side of the Base (91) in the same way. 2. Pull the Upright Wire (77) and the ground wire (A) through the indicated hole in the Base (91). 2 Attach the ground wire (A) to the Base (91) with a #8 x 1/2" Ground Screw (10). Press the Grommet (75) into the square hole in the Base (91). 91 2 92 57 Cardboard 75 Hole 77 3. Identify the Left Upright (88), which is marked "Left." Have a second person hold the Left 3 Upright near the Base (91). See the inset drawing. Tie the wire tie in the Left Upright (88) securely around the Upright Wire (77) about 8 in. (20 cm) down from the end. Then, pull the other end of the wire tie until the Upright Wire is routed through the Left Upright. Note: The Upright Wire should bend so that the connectors are pointing downward. A 10 91 77 88 Wire Tie Wire Tie 77 88 77 91 7