HealthRider H600 Treadmill English Manual - Page 29
Battery Cover
View all HealthRider H600 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
b. If the walking belt slips when walked on, remove the key and UNPLUG THE POWER CORD. Using the b hex key, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 5-7 cm (2-3 in.) off the walking platform. Be careful to keep the walking belt centred. Then, plug in the power cord, insert the key, and walk on the treadmill for a few min- utes. Repeat until the walking belt is properly tight- ened. PROBLEM: The chest pulse sensor does not function properly SOLUTION: a. If the chest pulse sensor does not function properly, see CHEST PULSE SENSOR TROUBLESHOOTING on page 9. b. If the chest pulse sensor still does not function properly, the battery should be changed. To replace the battery, first locate the battery cover on the back of the sensor unit. Insert a coin into the slot in the cover, and turn the cover counterclockwise to the "open" position. Then, remove the cover. b Battery Cover Next, remove the old battery from the sensor unit, and insert a new CR 2032 battery, with the battery oriented so the writing is on top. Make sure that the rubber gasket is in place in the sensor unit. Then, reinsert the battery cover and turn it to the closed position. Battery Cover Battery Rubber Gasket PROBLEM: The incline of the treadmill does not change correctly SOLUTION: a. With the key in the console, press one of the Incline buttons. Whilst the incline is changing, remove the key. After a few seconds, reinsert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system. 29