HP 3PAR StoreServ 7400 2-node HP 3PAR Management Console 4.3.1 User's - Page 31

The Summary tab provides the following information: Group General Field Position Label Port WWN Node WWN Type Rate Connected Device Type Connected Device Mode State MAC TPGT Resources Total Data Throughput Settings (displayed Connection Mode for FC and RCFC ports) Connection Type Description Port location in Node:Slot:Port format. The designated port label. Port World Wide Name. Node World Wide Name. Indicates whether the port is FC, iSCSI, RCIP, or RCFC. Rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4 Gbps). When there is no specified value, no connection exists. Type of device that the port is connected to: Free, Disk, Host, Peer, RC, or InServ. Name of device that the port is connected to, e.g. host1, cage0. Port firmware mode setting. Ports in Initiator mode are connected to drive cages and ports in Target mode export to hosts. Suspended mode is for target ports that have not yet been initialized by the system (rare). Peer mode is for Ethernet ports. Current state of the port: Ready, Login Wait, Loss Sync, or Offline. For iSCSI ports. The Media Access Control address for the Ethernet interface. For iSCSI ports. The Target Portal Group Tag for the iSCSI target portal group. The throughput in KB/sec. (Not shown for RCFC or Persistence ports.) The type of port connection. Connection type or port connection setting (Loop, Point, or Loop-point). When the port is set to Loop-point, both loop and point-to-point connections are enabled. Viewing System Ports 31