HP 3PAR StoreServ 7400 2-node HP 3PAR Management Console 4.3.1 User's - Page 32
For iSCSI ports. Indicates if the Dynamic Host Configuration Protocol DHCP
View all HP 3PAR StoreServ 7400 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Group Field Description Configured Rate Data transfer rate setting (for example, 1 Gbps). Auto indicates that the system automatically selects the rate. Max Rate Maximum rate of connection from the port. Class 2 Indicates whether Fibre Channel service Class 2 is Disabled, Ack 1 or Ack 0. VCN For fabric attached ports, indicates the VLUN change notification setting. When set to Enabled, notices are generated and sent to the fabric controller. When set to Disabled, no notification is sent. Unique Node WWN Indicates whether the node's WWN is Enabled or Disabled. Interrupt Coalesce If disabled, each I/O generates a separate interrupt to the HBA port driver rather than generating one interrupt for multiple I/O completion. IP Settings MAC (displayed for RCIP and iSCI ports) DHCP For RCIP ports. Media Access Control address of the Ethernet interface. For iSCSI ports. Indicates if the Dynamic Host Configuration Protocol (DHCP) protocol is enabled. IP Address IP address of the iSCSI or RCIP port. Gateway The address of a local IP router on the same network as the system, used to forward traffic to destinations beyond the local network. Subnet Mask Netmask address for the iSCSI or RCIP interface. MTU Maximum Transmission Unit. The greatest amount of data or "packet" size that can be transferred at one time over a particular network connection without overburdening the connection. The default MTU setting for an iSCSI port is 1500. When supported by the network, an MTU value of 9000 should be used. Configured Rate (For RCIP ports.) The configured data transfer rate. A value of 0 indicates that no data is being transferred. Rate (For iSCSI ports.) Data transfer rate. A value of 0 indicates that no data is being transferred. TCP Port (For iSCSI ports.)The TCP port number used by the iSCSI card. Duplex (For RCIP ports.) The duplex speed, Half or Full. Adapter Type (For RCIP ports.) Model of the adapter that contains the port (for example, Intel PRO/1000MT). Fibre Channel Settings (displayed for FC and RCFC ports) Topology Class Adaptor Type Type of connection (Private Loop, Public Loop, or Point-Point). Identifies which Fibre Channel classes of service are enabled (2, 3, or 2/3). 2/3 indicates that both Class 2 and Class 3 are enabled. Model of the Fibre Channel adapter that contains the port (for example, QLOGIC 2302). Remote Node WWN (For RCFC ports.) The node WWN. Remote Port WWN (For RCFC ports.) The port WWN. Mode Change Indicates whether port mode change from initiator to target or vice versa is Allowed or Prohibited. This setting is configured using the HP 3PAR CLI command controlport. Hosts The number of hosts connected to the port. (This is only displayed if the port is connected to hosts.) Physical Disks The number of physical disks connected to the port. This is only displayed if the port is connected to drive cages. 32 Managing Ports