HP 3PAR StoreServ 7450 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 129
creatercopytarget
View all HP 3PAR StoreServ 7450 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
creatercopytarget DESCRIPTION The creatercopytarget command creates a Remote Copy target definition. SYNTAX The syntax for the creatercopytarget command can be one of the following: • Syntax for Remote Copy over IP (RCIP) is as follows: creatercopytarget [options] IP []... • Syntax for Remote Copy over Fibre Channel (RCFC) is as follows: creatercopytarget [options] FC []... AUTHORITY • Super, Edit • Any role that is granted the rcopytarget_create right. NOTE: You need access to all domains in order to run this command. OPTIONS -disabled Create the target in disabled mode. SPECIFIERS The name of the target definition to be created, specified by using up to 23 characters. The node's World Wide Name (WWN) on the target system (Fibre Channel target only). []... Specifies the node, slot, and port of the Ethernet port on the local system and an IP address of the peer port on the target system. This specifier can be repeated. []... Specifies the node, slot, port of the Fibre Channel adaptor port on the primary system and World Wide Name (WWN) of the peer port on the target system. This specifier can be repeated. RESTRICTIONS Functionality of this command requires the HP 3PAR Remote Copy license. Contact your local service provider for more information. EXAMPLES The following example creates a target definition named System2 on the primary system, where the node numbers of the primary system's Ethernet ports are located at 0:3:1 and 1:3:1 and the corresponding IP addresses on the backup system are 10.1.1.11 and 10.1.2.11: # creatercopytarget System2 IP 0:3:1:10.1.1.11 1:3:1:10.1.2.11 creatercopytarget 129