HP 3PAR StoreServ 7450 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 616

statqos DESCRIPTION The statqos command displays the run-time stats of active QoS rules. SYNTAX The syntax for the showqos command can be one of the following examples: • statqos [options][{vvset:|}|sys:all_others}]... AUTHORITY • Any role in the system OPTIONS -domain {}... Shows rules with target objects in domains with names that match one or more of the specified domains or patterns. If -domain is not specified, all rules with target objects in the current domain are shown. See the currentdomain parameter in the setclienv and showclienv commands. -vv {|[{|}]... Applies only to QoS rules whose targets include virtual volumes with names matching any of the names or patterns specified. -rw Specifies that the display includes separate read and write data. If not specified, the total is displayed. -d Specifies the interval in seconds that statistics are sampled from using an integer from 1 through 2147483. If no count is specified, the command defaults to 2 seconds. -iter Specifies that the statistics are to stop after the indicated number of iterations using an integer from 1 through 2147483647. -begin Specifies that I/O averages are computed from the system start time. If not specified, the average is computed since the first iteration of the command. -idlep Specifies the percent of idle columns in the output. -sortcol [,][:[,]... Sorts command output based on column number (). Columns are numbered from left to right, beginning with 0. At least one column must be specified. In addition, the direction of sorting () can be specified as follows: inc Sort in increasing order (default). dec Sort in decreasing order. NOTE: Multiple columns can be specified and separated by a colon (:). Rows with the same information in them as earlier columns will be sorted by values in later columns. -filt 616 Stat Commands