HP 3PAR StoreServ 7450 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 208
locatenode, Blinks the hotplug LED for the specified power supply.
View all HP 3PAR StoreServ 7450 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 208 highlights
locatenode DESCRIPTION The locatenode command helps locate a particular node or its components by blinking LEDs on the node. By default all LEDs on the node will blink. SYNTAX locatenode [options] AUTHORITY • Super, Service • Any role granted the node_locate right. NOTE: You need access to all domains in order to run this command. OPTIONS -t Specifies the number of seconds, from 0 through 255, to blink the LEDs. If not specified, the option defaults to 60 seconds. -ps Blinks the hotplug LED for the specified power supply. -pci Blinks the hotplug LED corresponding to the PCI card in the specified slot. -fan Blinks the hotplug LED on the specified node fan module. -drive Blinks the hotplug LED corresponding to the node's internal drive. -bat Blinks the hotplug LED on the battery backup unit. SPECIFIERS Indicates which node the locatenode operation will act on. Accepted values are 0 through 7. RESTRICTIONS Access to all domains is required to run this command. EXAMPLES In the following example, power supply 1 on node 3 is identified by blinking its hotplug LED for 90 seconds cli% locatenode -t 90 -ps 1 3 NOTES None. 208 Locate Commands