HP 3PAR StoreServ 7450 2-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 581

startnoderescue DESCRIPTION The startnoderescue command initiates a node rescue, which initializes the internal node disk of the specified node to match the contents of the other node disks. The copy is done over the network, so the node to be rescued must have an Ethernet connection. It will automatically select a valid unused link local address. Progress is reported as a task. SYNTAX startnoderescue -node AUTHORITY Super, Service OPTIONS -node Specifies the node to be rescued. This node must be physically present in the system and powered on, but not part of the cluster. SPECIFIERS Specifies the node to be rescued. This node must be physically present in the system and powered on, but not part of the cluster. EXAMPLES The following example show starting a node rescue of node 2. cli% startnoderescue -node 2 Node rescue from node 0 to node 2 started. cli% showtask Id Type Name Status Phase Step -------StartTime------- -FinishTime- -Priority- ---User---- 96 node_rescue node_2_rescue active 1/1 0/1 2012-06-15 18:19:38 PDT - n/a sys:3parsys NOTES On systems other than T and F-class, node rescue will automatically be started when a blank node disk is inserted into a node. The startnoderescue command only needs to be manually issued if the node rescue must be re-run on a disk that is not blank. For T and F-class systems, startnoderescue must always be issued to perform a node rescue. startnoderescue 581