HP 3PAR StoreServ 7450 2-node HP 3PAR StoreServ 7450 Storage Installation Guid - Page 54
Welcome Set up systems
View all HP 3PAR StoreServ 7450 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
NOTE: When configuring in a DHCP network environment, enter the VSP temporary IP address. Figure 46 Set up systems Page 4. On the browser window, enter setupusr in the User Name box, and leave the password box blank. 5. Click OK. NOTE: The Service Processor Setup Wizard may not display correctly when using Microsoft Internet Explorer 10 with default security settings. If the wizard continues to display incorrectly, try refreshing the browser page. Welcome Page The Welcome page shows the information that is required to complete the wizard and set up the SP. Follow the instructions on each screen, and then click Next. The setup takes about 15 minutes. You must have the following information: • StoreServ 7-digit serial number • SP network configuration: ◦ The name to be assigned to the Service Processor ◦ IP address (IPv4 only) ◦ Subnet mask and gateway, if you are using custom settings ◦ DNS settings, if you plan to enable the Domain Name System 54 Setting Up the Service Processor and Storage System