HP 4400 HP StorageWorks Fabric OS 6.2.2e Release Notes (5697-0809, February 20 - Page 14

DC SAN Backbone and DC04 SAN Director blade support Fabric OS 6.2.2e is fully qualified and supports the DC Director blades listed in Table 3 (page 14). Table 3 DC Director blade support matrix Director blade FC8-16 FC8-32 FC8-48 FC10-6 Number of blades Supported with Fabric OS 6.0.0b or later with any mix, with up to eight blades of each type on the DC SAN Backbone Director. There are no intermix restrictions. The DC04 SAN Director requires Fabric OS 6.2.0a or later, and supports up to four blades. FC4-16IP (iSCSI blade) FR4-18i (FCIP/FC Router blade) FS8-18 (DC Switch Encryption FC blade) Not supported with the DC SAN Backbone Director or DC04 SAN Director Supported with Fabric OS 6.0.0b or later, with a maximum of four blades of this type on the DC SAN Backbone Director. Up to eight FR4-18i blades can be installed if they are used only for FC Fast Write or FCIP without routing in the DC SAN Backbone Director. The DC04 SAN Director requires Fabric OS 6.2.0a or later, and supports up to four blades. Supported with Fabric OS 6.2.0b or later, with a maximum of four blades of this type on the DC SAN Backbone Director or DC04 SAN Director Power supply requirements for Director blades Table 4 (page 14) lists power supply requirements for Director blades to provide full redundancy (220 VAC power is assumed). IMPORTANT: Director blades must meet minimum Fabric OS levels to operate in the Director chassis. For example, the FC8-32 is not supported in the 4/256 SAN Director with Fabric OS 6.0.x. Table 4 Power supplies required for blades in director chassis Director blade FC4-16 FC4-32 FC4-48 FC8-16 FC8-32 4/256 SAN Director Two power supplies DC SAN Backbone Director and DC04 SAN Director1 Two power supplies FC8-48 FC10-6 Four power supplies Two power supplies 14