HP 4400 HP StorageWorks Fabric OS 6.2.2e Release Notes (5697-0809, February 20 - Page 34

Table 8 Fabric OS 6.2.1 closed defects Closed defect summary Solution Sshd allows admin login to execute root-level Linux commands, but admin Fixed in Fabric OS 6.2.1 CLI commands fail with a command not found error. Workaround prior to update: A workaround to facilitate execution of admin level CLI commands using ssh, is to use syntax similar to ssh -l admin 192.168.1.12 rbash --login -c switchshow. Or, if a command is needed that works on both older (correctly operating) Fabric OS and the newer/affected Fabric OS: ssh -l admin 192.168.1.12 switchshow || rbash --login -c switchshow. On rare occasions, an extra RSCN is delivered when HA failover is performed before the name server is in sync. Fixed in Fabric OS 6.2.1 Firmware is not enforcing a mandatory switch disable before configuring Fixed in Fabric OS 6.2.1 the backbone fabric ID. Common Area Loader Daemon (CALD) shared memory is not released, Fixed in Fabric OS 6.2.1 leading to high CPU load and inability to run many of the CLI commands; causes no space left on device error. Workaround prior to update: Run hafailover prior to the upgrade. In mixed Fabric OS and M-EOSc fabric in interopmode 2, with more than Fixed in Fabric OS 6.2.1 500 devices, nameserver database counts do not match. This issue does not exist with M-EOSn based switches in a mixed fabric. Toggling the N_Port could cause the F_Port to get disabled, leading to the Fixed in Fabric OS 6.2.1 crypto LUN getting stuck in a Not ready (LUN rediscovery) state with HP StorageWorks Encryption SAN Switch in Access Gateway mode. A switch having a zone object with an extra ";" or -p flag for a zone create Fixed in Fabric OS 6.2.1 does not perform an error check for alphanumeric characters, which can trigger loss of zone configuration after a firmware upgrade, or can cause a switch panic after the cfgenable command. In Access Gateway mode, the FDMI database does not show proper Fixed in Fabric OS 6.2.1 information after disabling the port connected to an HBA. Brocade_Software Identity instance for the remaining node is missing in Brocade SMIA. During a stress test with switchdisable/switchenable of all switches Fixed in Fabric OS 6.2.1 in a fabric, we observed both verify failure and a switch panic in the RTE module. A small timing window exists due to a corner case where, if a device sends Fixed in Fabric OS 6.2.1 PLOGI before the route is set up, it could cause PLOGI to drop in single switch fabric. This is caused by race condition where PLOGI is transmitted prior to the name server query, when the internal route has not yet been established for the WWN zoning pair. Authentication fails after 15 minutes if external authentication, such as LDAP Fixed in Fabric OS 6.2.1 or Radius server, is configured. The user is not able to login using Web Tools or web page. Invalid password is reported. This issue does not occur when the CLI is used. I/O cannot resume when jamming the status frame with IDLE with QoS enabled. Link reset does not load the buffers correctly and I/O can be disrupted Fixed in Fabric OS 6.2.1 A Common Area Loader Daemon (CALD) memory leak occurs while running Fixed in Fabric OS 6.2.1 management applications using the SMI interface. This causes a switch panic/restart and fabric disruption. 34