HP 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June - Page 662
switchCfgPersistentEnable, Synopsis, Description, Operands, Examples, See Also, switchDisable
View all HP 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 662 highlights
2 switchCfgPersistentEnable switchCfgPersistentEnable Enables a switch persistently. Synopsis switchcfgpersistentenable Description Use this command to persistently enable the switch. All Fibre Channel ports that passed the power-on self-test (POST) are enabled and come online if connected to a device, or remain offline if disconnected. The switch might need to be enabled if it was previously disabled to make configuration changes or to run diagnostics. If the switch is connected to a fabric, it rejoins the fabric. After this command is issued, the 10 second fabric stability count down is displayed. If this switch remains the principal switch at the end of the count down, then it assigns itself a domain ID. If another switch assumes the principal role, then this switch becomes a subordinate switch, and accepts a domain ID from the principal. Refer to the FC-SW specification for a complete description of this process. The enable process can be observed and verified by watching the front panel LEDs change from slow flashing yellow as each port is enabled. The LEDs change to green for online ports, or can remain black for disconnected ports, or yellow for ports that do not initialize. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability" for details. Operands none Examples To configure the switch as persistently enabled: switch:admin> switchcfgpersistentenable 10 9 8 7 6 5 4 3 2 1 fabric: Principal switch fabric: Domain 1 See Also switchDisable, switchEnable, switchCfgPersistentDisable, switchShow 636 Fabric OS Command Reference 53-1000599-02