HP BL680c HP Virtual Connect Enterprise Manager User Guide - Page 53
Creating a profile, Configuring the target boot LUN
UPC - 884420396314
View all HP BL680c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
power off the server blade to perform server profile operations with VC firmware 2.0x or 2.1x. However, in VC firmware 2.3x, you can perform these operations with the server blade powered on. Creating a profile NOTE: Depending on the VC Domain version, the create profile page displays a different set of configurations. To verify the available features for each VC Domain version, see the feature set table earlier in this section. NOTE: In a VC Domain Group with VC firmware 2.1x, the 8Gb FC module appears only if VCEM detects it. If VCEM detects the 4Gb FC module, then the maximum port speed will be 4Gb. 1. From the Profiles page, click New. 2. From the Member of VC Domain Group menu, select the VC Domain Group to which the profile will belong. The Create New Profile information appears below the profiles list. 3. In the Profile name box, enter a unique profile name. 4. (Optional) To use factory-assigned MAC addresses and WWNs, and override the VCEM-provided settings, select Show advanced settings. If you choose to use factory-assigned MAC addresses, WWNs, and serial numbers, these changes apply to every Ethernet and Fibre Channel connection in a server profile. • To use server factory defaults for Ethernet MAC addresses, select Use Server Factory Defaults for Ethernet MAC addresses. • To use server factory defaults for Fibre Channel WWNs, select Server Factory Defaults for Fibre Channel WWNs. • To use server factory defaults for Serial Number, select Server Factory Defaults for Serial Number. 5. In the Ethernet network connections table, select at least two Ethernet networks. Network names are optional. In a VC Domain, it is possible to select Multiple Networks. To add more connections, click Add Network Connection. To remove a connection, click the X icon at the right side of the table. 6. In the Fibre Channel SAN connections table, set the Fibre Channel SAN connections. To add more connections in a VC Domain, click Add FC SAN Connection. To remove a connection, click the X icon at the right side of the table. 7. (Optional) In the Fibre Channel Boot Parameters table, enter the boot parameters for defined Fibre Channel SAN connections. The default boot parameter is Use Bios. The World Wide Part Number (WWPN) and Logical Unit Number (LUN) are required only for the primary and secondary SAN boot. 8. (Optional) To create the bay assignment, select VC Domain, and then select an available target server bay. If a profile is not assigned to a server bay or fails to assign to a server bay, then that profile becomes unassigned to a VC Domain Group. 9. Click OK. The Virtual Connect Enterprise Manager is executing the request message appears. 10. Click OK to go to the Jobs page and monitor job progress. NOTE: To create profiles for Integrity Blades that boot from SAN, you must manually configure the SAN boot entries in the blade server EFI console. Configuring the target boot LUN When creating or editing server profiles, you can specify a target boot LUN for the FC SAN connections designated as Primary and Secondary in the boot priority column. Profiles 53