HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 435

FW-1051 45 Recommended Configure the low threshold to 1 so that the threshold triggers an alarm when the value falls to 0 Action (Out_of_Range). If continuous or repeated alarms occur, replace the SFP before it deteriorates. Severity WARNING FW-1051 Message , [FW-1051], ,, WARNING, , , is above high boundary(High=, Low=). Current value is . Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has risen above the high boundary. High voltages indicate possible hardware failures. Recommended Frequent voltage fluctuations indicate that the SFP is deteriorating. Replace the SFP. Action Severity WARNING FW-1052 Message , [FW-1052], ,, INFO, , , is between high and low boundaries(High=, Low=). Current value is . Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has changed from a value outside of the acceptable range to a value within the acceptable range. Recommended No action is required. Respond to this message as is appropriate to the particular policy of the Action end-user installation. Severity INFO FW-1053 Message , [FW-1053], ,, WARNING, , , is below low boundary(High=, Low=). Current value is . Probable Cause Indicates that the value of the small form-factor pluggable (SFP) Power on Hours has fallen below the low boundary. Recommended Configure the low threshold to 1 so that the threshold triggers an alarm when the value falls to 0 Action (Out_of_Range). If continuous or repeated alarms occur, replace the SFP before it deteriorates. Severity WARNING Fabric OS Message Reference 349 53-1002448-01