HP Brocade 8/12c Brocade Fabric OS Command Reference Manual Supporting Fabric - Page 133
cfgEnable, cfgClear, cfgSave, cfgShow
View all HP Brocade 8/12c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
22 cfgEnable cfgEnable SYNOPSIS Enables a zone configuration. cfgenable "cfgName" DESCRIPTION Use this command to enable a zone configuration. The command builds the specified zone configuration . It checks for undefined zone names, zone alias names, or other inconsistencies, by expanding zone aliases, removing duplicate entries, and then installing the effective configuration. If the build fails, the previous state is preserved (zoning remains disabled, or the previous effective configuration remains in effect). If the build succeeds, the new configuration replaces the previous configuration. Refer to the cfgShow command for a description of the defined and effective configurations. NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. When an FCS policy is enabled, this command can be issued only from the primary FCS switch. OPERANDS The following operand is required: "cfgName" Specifies the name of the zone configuration. The name must be enclosed in double quotation marks. EXAMPLES To enable the zone configuration USA_cfg: switch:admin> cfgenable "USA_cfg" You are about to enable a new zoning configuration. This action will replace the old zoning configuration with the current configuration selected. Do you want to enable 'USA_cfg' configuration \ (yes, y, no, n): [no] y zone config "USA_cfg" is in effect Updating flash ... SEE ALSO cfgClear, cfgDisable, cfgSave, cfgShow Fabric OS Command Reference 99 53-1001764-01